EN / ES — Español

Case study · Industrial AI & IoT

Dosing pump control

Remote control of dosing pumps over telemetry, adjusting the dose to the flow and concentrations entering the plant.

My role
Design, specification and development of the module
Industry
Water treatment
Status
In production
Industrial valves with red handwheels in a pump room
Illustrative photo. Photo by Alexandre Daoust on Unsplash.

01 · Problem

Dose just right, from a distance

In many plants, the dosing pump and its control panel are far from where operators work. Adjusting the dose meant walking out to the equipment.

On top of that, the right dose is not fixed: it depends on the flow entering the plant and its concentrations, which change during the day. The challenge was to dose just right without someone adjusting the pump by hand.

02 · Solution

Remote control driven by plant data

A telemetry-based pump control system: from the platform you switch the pump on and set the dosing flow, without going on site. It has several operating modes, for example keeping a constant chemical concentration.

The innovation was bringing in the plant’s inflow parameters, such as flow and concentrations, so the dosing adjusts itself and closes the loop between the data and the physical action.

Under the hood, the module turns the target dose into the drive frequency, uses each pump’s calibration curve, and logs the dosing and its alarms. It includes an in-house simulator to test it without real equipment.

03 · How it works

The loop and the curve

chemicaldosed↻closedloopPlantinflow, concentrationPlatformtarget dose by modeCalibration curveflow → frequencyRemote controlcommand over MQTTDrivesets the frequencyDosing pumplogging and alarmsdrive frequency →pump flow →validated fittarget flowoperating frequencyfield calibration
Fig. 1 — Illustrative diagram, no real values. Left: the closed loop, where plant inflow data adjusts the dose without anyone going on site. Right: how each pump’s calibration curve turns the target flow into the drive frequency.

04 · My contribution

I built the module end to end

I designed, specified and developed the entire module, including the simulator to test it without field equipment.

05 · Technologies

Tools

PythonDjangoMQTTCelery